Electrical Instruments
PHXII03:CURRENT ELECTRICITY

357303 Figure shows a potentiometer circuit for measuring the internal resistance \(r\) of a cell \(Y\). When the cell is an open circuit, \(T\) is the balance point on the wire \(P Q\). The resistor \(R^{\prime}\) is used
supporting img

1 to make the galvanometer \(G\) more sensitive.
2 to produce a long balance length.
3 because \(G\) is sensitive galvanometer.
4 to protect the potentiometer wire.
PHXII03:CURRENT ELECTRICITY

357304 \(A B\) is a potentiometer wire of length \(100\;cm\) and its resistance is \(10\,ohm\). It is connected in series with a resistance \(R = 40\,ohm\) and a battery of \(e.m.f.\) \(2{\rm{ }}V\) and negligible internal resistance. If a source of unknown \(e.m.f.\) \(E\) is balanced by \(40\;cm\) length of the potentiometer wire, the value of \(E\) is:
supporting img

1 \(0.8\;V\)
2 \(0.16\;V\)
3 \(0.08\;V\)
4 \(1.33\;V\)
PHXII03:CURRENT ELECTRICITY

357305 Statement A :
The e.m.f of the driver cell in the potentiometer experiment should be greater that the e.m.f of the cell whose emf is to be determined.
Statement B :
The potential difference across the potentiometer wire should not be less than the e.m.f of the cell to be determined

1 Statement A is correct but Statement B is incorrect.
2 Statement A is incorrect but Statement B is correct.
3 Both Statements are correct.
4 Both Statements are incorrect.
PHXII03:CURRENT ELECTRICITY

357306 A potentiometer wire of length 10\(m\) is connected in series with a battery. The emf of a cell balances aganist 250 \(cm\) length of wire. If length of potentiometer wire is increased by 1\(m\), then new balancing length of wire will be

1 \(2.00m\)
2 \(2.25m\)
3 \(2.50m\)
4 \(2.75m\)
PHXII03:CURRENT ELECTRICITY

357303 Figure shows a potentiometer circuit for measuring the internal resistance \(r\) of a cell \(Y\). When the cell is an open circuit, \(T\) is the balance point on the wire \(P Q\). The resistor \(R^{\prime}\) is used
supporting img

1 to make the galvanometer \(G\) more sensitive.
2 to produce a long balance length.
3 because \(G\) is sensitive galvanometer.
4 to protect the potentiometer wire.
PHXII03:CURRENT ELECTRICITY

357304 \(A B\) is a potentiometer wire of length \(100\;cm\) and its resistance is \(10\,ohm\). It is connected in series with a resistance \(R = 40\,ohm\) and a battery of \(e.m.f.\) \(2{\rm{ }}V\) and negligible internal resistance. If a source of unknown \(e.m.f.\) \(E\) is balanced by \(40\;cm\) length of the potentiometer wire, the value of \(E\) is:
supporting img

1 \(0.8\;V\)
2 \(0.16\;V\)
3 \(0.08\;V\)
4 \(1.33\;V\)
PHXII03:CURRENT ELECTRICITY

357305 Statement A :
The e.m.f of the driver cell in the potentiometer experiment should be greater that the e.m.f of the cell whose emf is to be determined.
Statement B :
The potential difference across the potentiometer wire should not be less than the e.m.f of the cell to be determined

1 Statement A is correct but Statement B is incorrect.
2 Statement A is incorrect but Statement B is correct.
3 Both Statements are correct.
4 Both Statements are incorrect.
PHXII03:CURRENT ELECTRICITY

357306 A potentiometer wire of length 10\(m\) is connected in series with a battery. The emf of a cell balances aganist 250 \(cm\) length of wire. If length of potentiometer wire is increased by 1\(m\), then new balancing length of wire will be

1 \(2.00m\)
2 \(2.25m\)
3 \(2.50m\)
4 \(2.75m\)
PHXII03:CURRENT ELECTRICITY

357303 Figure shows a potentiometer circuit for measuring the internal resistance \(r\) of a cell \(Y\). When the cell is an open circuit, \(T\) is the balance point on the wire \(P Q\). The resistor \(R^{\prime}\) is used
supporting img

1 to make the galvanometer \(G\) more sensitive.
2 to produce a long balance length.
3 because \(G\) is sensitive galvanometer.
4 to protect the potentiometer wire.
PHXII03:CURRENT ELECTRICITY

357304 \(A B\) is a potentiometer wire of length \(100\;cm\) and its resistance is \(10\,ohm\). It is connected in series with a resistance \(R = 40\,ohm\) and a battery of \(e.m.f.\) \(2{\rm{ }}V\) and negligible internal resistance. If a source of unknown \(e.m.f.\) \(E\) is balanced by \(40\;cm\) length of the potentiometer wire, the value of \(E\) is:
supporting img

1 \(0.8\;V\)
2 \(0.16\;V\)
3 \(0.08\;V\)
4 \(1.33\;V\)
PHXII03:CURRENT ELECTRICITY

357305 Statement A :
The e.m.f of the driver cell in the potentiometer experiment should be greater that the e.m.f of the cell whose emf is to be determined.
Statement B :
The potential difference across the potentiometer wire should not be less than the e.m.f of the cell to be determined

1 Statement A is correct but Statement B is incorrect.
2 Statement A is incorrect but Statement B is correct.
3 Both Statements are correct.
4 Both Statements are incorrect.
PHXII03:CURRENT ELECTRICITY

357306 A potentiometer wire of length 10\(m\) is connected in series with a battery. The emf of a cell balances aganist 250 \(cm\) length of wire. If length of potentiometer wire is increased by 1\(m\), then new balancing length of wire will be

1 \(2.00m\)
2 \(2.25m\)
3 \(2.50m\)
4 \(2.75m\)
PHXII03:CURRENT ELECTRICITY

357303 Figure shows a potentiometer circuit for measuring the internal resistance \(r\) of a cell \(Y\). When the cell is an open circuit, \(T\) is the balance point on the wire \(P Q\). The resistor \(R^{\prime}\) is used
supporting img

1 to make the galvanometer \(G\) more sensitive.
2 to produce a long balance length.
3 because \(G\) is sensitive galvanometer.
4 to protect the potentiometer wire.
PHXII03:CURRENT ELECTRICITY

357304 \(A B\) is a potentiometer wire of length \(100\;cm\) and its resistance is \(10\,ohm\). It is connected in series with a resistance \(R = 40\,ohm\) and a battery of \(e.m.f.\) \(2{\rm{ }}V\) and negligible internal resistance. If a source of unknown \(e.m.f.\) \(E\) is balanced by \(40\;cm\) length of the potentiometer wire, the value of \(E\) is:
supporting img

1 \(0.8\;V\)
2 \(0.16\;V\)
3 \(0.08\;V\)
4 \(1.33\;V\)
PHXII03:CURRENT ELECTRICITY

357305 Statement A :
The e.m.f of the driver cell in the potentiometer experiment should be greater that the e.m.f of the cell whose emf is to be determined.
Statement B :
The potential difference across the potentiometer wire should not be less than the e.m.f of the cell to be determined

1 Statement A is correct but Statement B is incorrect.
2 Statement A is incorrect but Statement B is correct.
3 Both Statements are correct.
4 Both Statements are incorrect.
PHXII03:CURRENT ELECTRICITY

357306 A potentiometer wire of length 10\(m\) is connected in series with a battery. The emf of a cell balances aganist 250 \(cm\) length of wire. If length of potentiometer wire is increased by 1\(m\), then new balancing length of wire will be

1 \(2.00m\)
2 \(2.25m\)
3 \(2.50m\)
4 \(2.75m\)